How to Use a Scalp Massager Brush (Step by Step)

Silicone scalp massager shampoo brush

To use a scalp massager brush, wet your hair, work a little shampoo into your scalp, then hold the brush flat against your scalp and move it in small, slow circles for 1 to 3 minutes, one section at a time from your hairline to the nape of your neck. Use light pressure, keep the brush on the scalp instead of dragging it through your lengths, then rinse your hair and the brush.

A scalp massager (also called a shampoo brush or scalp scrubber) is a small handheld brush with soft, flexible bristles. It does the job your fingertips do in the shower, a little more evenly, and without your nails. Below is how to use one in the shower, on dry hair, on long or curly hair, and how to keep it clean. We use our silicone scalp massager shampoo brush as the example, but the method works with most silicone scalp brushes.

What you need

  • A scalp massager brush with soft bristles. Our silicone shampoo brush fits in the palm of your hand and comes in purple, red, green, blue and black.
  • Your usual shampoo (and conditioner). If you are building a wash routine, our guide on how to use rosemary shampoo, conditioner and hair mask walks through the order and timing.
  • A wide-tooth comb to detangle before and after washing.
  • Optional: a hair oil if you like a pre-wash oil massage on dry hair.

How to use a scalp massager in the shower, step by step

  1. Detangle first. Comb out knots while your hair is dry. A scalp brush works on the scalp, so you don't want it catching on tangles in the lengths.
  2. Wet your hair completely. Let warm water run through to the scalp for 30 seconds or so, especially if your hair is thick.
  3. Apply shampoo to the scalp. Use your normal amount and spread it over your scalp with your fingertips. You can also put a small amount on the brush itself.
  4. Place the brush flat on your scalp. Start at the hairline. Hold it so all the bristles touch the scalp at once rather than tilting it onto the edge.
  5. Move in small, slow circles. Use light to medium pressure, about as firm as a fingertip massage. Spend a few seconds on each spot, then lift the brush and move to the next one.
  6. Work in sections. Go from the front hairline back over the crown, then down the sides behind your ears and finish at the nape. One full pass usually takes 1 to 3 minutes.
  7. Rinse well. Rinse until the water runs clear and your scalp no longer feels slippery. Leftover shampoo at the roots is a common cause of that heavy, greasy feeling a day later.
  8. Condition the lengths, not the scalp. Apply conditioner from mid-lengths to ends. You can comb it through with a wide-tooth comb, but skip the scalp brush for this step.
  9. Rinse the brush and let it dry. Shake out the water and stand it somewhere it can air-dry.

How to use a scalp massager on dry hair

You can also use a scalp brush before you wash. Brush your hair out, part it into a few sections, and massage each one with small, gentle circles for a minute or two. This helps loosen flakes and build-up so your shampoo can rinse them away, and many people just like how it feels.

If you like a pre-wash oil treatment, put a few drops of oil on your scalp first, then massage it in with the brush and wash it out as normal. Our guide on how to use hair oil explains how much to use for your hair type. On dry hair, keep the pressure especially light, since there is no water or lather to help the bristles glide.

Tips for long, curly or thick hair

  • Long hair: keep the brush on the scalp and use small circles or short back-and-forth strokes in place. Dragging it down the lengths is what causes tangles.
  • Curly or coily hair: detangle with conditioner or a wide-tooth comb beforehand, part your hair into four sections, and work through each part line. Gentle, small movements help keep curl clumps together.
  • Thick hair: use more sections, not more pressure. Make sure the water and shampoo actually reach the scalp before you start.
  • Short hair: you can move the brush more freely, since there is less length to tangle.

How often should you use a scalp massager?

Most people use a scalp brush every time they wash their hair, whether that is daily or a couple of times a week. A few minutes is plenty. More pressure or longer sessions don't do more. If your scalp feels sore, tender or irritated afterward, ease off: use lighter pressure, shorter sessions, or use it every other wash. Avoid any areas with cuts, sores or irritated skin.

Common scalp massager mistakes

  • Scrubbing too hard. A scalp brush should feel like a firm fingertip massage, not a scrub. Let the bristles do the work.
  • Dragging it through the lengths. Lift it and move it instead, especially on long hair.
  • Skipping the detangle. Knots plus a brush in circles equals more knots.
  • Not rinsing enough. Loosened build-up and shampoo need a thorough rinse to come out.
  • Leaving the brush wet and dirty. Hair and product collect between the bristles. Rinse it after every use.
  • Expecting it to fix a scalp condition. A scalp brush is a grooming tool. For persistent itching, flaking, redness or hair shedding, see a doctor or dermatologist.

How to clean a silicone scalp massager

Rinse the brush under warm water after every use and pull out any hair caught between the bristles. Once a week or so, wash it with warm water and a little mild soap, rinse it well, and let it dry completely before you store it. Our product listing recommends the same: clean it regularly with warm water and mild soap and dry it fully.

Our silicone scalp massager shampoo brush

Our massage silicone shampoo brush is a handheld scalp brush with soft silicone bristles for use in the shower or on dry hair. It comes in purple, red, green, blue and black, and it is $9.40, which makes it an easy add-on to your shampoo. Browse shampoos, conditioners and masks to pair it with in our hair care collection.

Every US order ships free, and new customers can use code WELCOME15 for 15% off their first order.

FAQ

How do you use a scalp massager in the shower?

Wet your hair completely, work a small amount of shampoo into your scalp with your fingertips, then place the brush flat on your scalp and move it in small, slow circles for about 1 to 3 minutes, section by section from the hairline to the nape. Use light pressure, then rinse your hair and the brush well.

Should you use a scalp massager on wet or dry hair?

Both work. On wet hair with shampoo, the brush helps spread the lather and loosen product build-up around the roots. On dry hair, a short, gentle massage before you wash is a relaxing way to loosen flakes and spread a pre-wash oil. Brush out knots first if you use it on dry hair.

How do you use a scalp massager without tangling your hair?

Detangle before you start, move the brush in small circles or short back-and-forth strokes in one spot instead of dragging it through the lengths, and lift it off the scalp to move to the next section. On long or curly hair, work in sections and keep the brush on the scalp, not the ends.

How often should you use a scalp massager?

Most people use one every time they wash their hair. Gentle short sessions of a few minutes are enough. If your scalp feels sore, tender or irritated, use less pressure, use it less often, or take a break.

Does a scalp massager help hair growth?

We don't make that promise. A scalp massager brush is a grooming tool: it helps you work shampoo into the scalp, lift build-up and enjoy a relaxing massage. It is not a treatment for hair loss or any scalp condition, so see a doctor or dermatologist if you are worried about shedding or thinning.