To use a hot air brush, start with clean hair that's about 80% dry, apply a heat protectant, and divide your hair into 2-inch sections. Place the brush under each section at the root, pull it slowly to the ends while the warm air flows, and roll the ends under or out. Use the lowest heat that works and finish on a cool setting to set the shape.
A hot air brush, sometimes called a one-step dryer brush or blow-dry brush, is a hair dryer and an oval round brush in one tool. It's the easiest way to get a smooth, bouncy blowout at home without juggling a dryer in one hand and a brush in the other. This guide walks through each step, what to change for short, medium or long hair, how to get curls or volume, and the mistakes that cause frizz. If you're shopping for one, our one-step hot air brush comes with a US plug.
What you'll need
- A hot air brush with a plug that fits US outlets
- A towel (microfiber or a hair towel wrap absorbs water with less rubbing)
- A heat protectant spray or cream
- Sectioning clips (3 to 4 large clips)
- Optional: a light hair oil for the ends
How to use a hot air brush, step by step
- Wash and condition. A hot air brush styles best on clean hair. Gently squeeze out water and wrap your hair in a towel for 10 to 15 minutes.
- Get your hair about 70 to 80 percent dry. Let it air-dry or rough-dry it with a regular dryer until it's damp, not wet. Starting on soaking-wet hair takes much longer and means more heat overall.
- Apply heat protectant. Mist or smooth it through from mid-lengths to ends, and comb it through so it's even.
- Section your hair. Clip the top half up. Start with the bottom layer at the back, working in sections about 2 inches wide, or about the width of the brush.
- Choose your heat. Start on low or medium. Go higher only if your hair is thick or coarse and isn't smoothing out.
- Brush from root to end. Place the brush under a section close to the roots, hold it for 2 to 3 seconds to lift, then pull it slowly down the length while keeping light tension. Repeat 2 or 3 times until the section feels dry.
- Shape the ends. At the end of each pass, rotate your wrist to roll the ends under for a classic blowout or outward for a flipped look.
- Work up to the top. Let down the next layer and repeat. For the crown and front sections, lift the hair straight up from the scalp before brushing back to get more lift.
- Cool and finish. If your brush has a cool setting, run it over each section once more. Otherwise, let your hair cool for a few minutes before touching it. Smooth a drop of oil over the ends if they look dry.
How to use a hot air brush on short, medium and long hair
Short hair and bobs
Use small sections and keep passes short. Roll under at the ends for a rounded bob, or flick the brush outward at the jawline for a playful flip. Avoid lingering on one spot, because short hair dries very quickly.
Medium hair
Medium, shoulder-length hair is where a hot air brush shines. Use 2-inch sections, lift at the roots and bend the ends under. For a "bouncy" '90s look, roll the brush in a full turn at the ends and hold for a few seconds before releasing.
Long or thick hair
Rough-dry first with a regular dryer so the hot air brush only has to finish and smooth. Work in more, smaller sections, and use clips to keep finished sections out of the way. Expect to take longer on the bottom layers, which hold the most water.
How to use a hot air brush to curl hair or add volume
A hot air brush makes soft waves and bends, not tight curls. For loose curls, wrap a damp-dry section around the barrel from the mid-lengths down, hold it for 5 to 10 seconds while the air runs, then switch to the cool setting or let it cool before gently sliding the brush out. Pin the curl in place with a clip while it cools for a longer-lasting shape.
For volume, focus on the roots: lift each top section straight up, place the brush at the base and hold it there for a few seconds before pulling through. Flip your part to the other side while styling, then flip it back at the end. If you want defined curls that last all day, a heat tool made for curling works better; see our guide to curling hair with a flat iron.
Hot air brush vs straightener vs blow dryer
- Hot air brush: dries and styles at the same time. Best for a smooth blowout with movement and volume.
- Flat iron (straightener): works on dry hair only and gives a sleeker, flatter finish with sharper edges. See how to straighten hair with a flat iron.
- Blow dryer plus round brush: more airflow and control, but harder to master and takes two hands.
Lots of people combine them: hot air brush for body, then a quick pass with a flat iron only on the ends if they want them extra sleek.
Common hot air brush mistakes
- Starting on wet hair. It slows everything down and adds unneeded heat time.
- Using the highest heat by default. Higher isn't faster for fine hair; it just makes frizz and flyaways more likely.
- Sections that are too big. The brush can't grip all the hair, so the inside stays damp and frizzes later.
- Skipping heat protectant. Use one every time you style with heat.
- Not cleaning the brush. Remove hair from the bristles after each use, and when the brush is unplugged and cool, wipe the barrel and check that the air vents are free of lint and dust.
About our one-step hot air brush
Our one-step hot air brush is an oval, black-and-pink hot air brush that dries and styles in one step. Here's what the listing and product photos show:
- Plug: choose the U.S. regulations option at checkout for a US two-prong plug. The product photos list 110 to 125V and 1000W for the US version.
- Brush: oval barrel with a ceramic and tourmaline coating, nylon pins and a 360-degree swivel cord.
- Heat: adjustable heat settings. Use it on damp or dry hair as described above.
- Price: $47.00, with free shipping on every US order.
New customers can use code WELCOME15 for 15% off their first order. Browse more styling tools and hair care in our hair care collection, and pair it with our guide on how to use hair oil for smoother ends.
FAQ
Do you use a hot air brush on wet or dry hair?
Use it on damp hair, not dripping-wet hair. Towel-dry or rough-dry with a regular dryer until your hair is about 70 to 80 percent dry, then finish with the hot air brush. On fully dry hair it works as a quick touch-up for bends, flat roots or frizzy ends, but it won't add as much shape as it does on damp hair.
What heat setting should I use on a hot air brush?
Start on the lowest setting and only go up if your hair isn't smoothing out. Fine, thin, bleached or color-treated hair usually needs low heat; thick or coarse hair may need a higher setting. Use a heat protectant first and finish each section on a cooler setting if your brush has one, to help the shape set.
Can you use a hot air brush on short hair or a bob?
Yes. On a bob or shoulder-length cut, work in smaller sections, roll the brush under at the ends for a curved finish, or flick it outward for a flipped look. Very short hair (shorter than the barrel can grip, roughly a few inches) is easier to style with a smaller round brush and a regular dryer.
Is a hot air brush better than a blow dryer and round brush?
It's easier rather than better. A hot air brush combines the dryer and the round brush in one tool, so you have a free hand and don't need to angle a nozzle at the brush. A dryer plus round brush gives more control and airflow, which can be faster on very long or thick hair. Many people rough-dry with a dryer and finish with a hot air brush.
Can you use a hot air brush on a synthetic wig or extensions?
Only if the manufacturer says the wig or extensions are heat-friendly, and then on the lowest setting. Standard synthetic fibers can melt or frizz from heat. Human-hair extensions can usually be styled like your own hair, but avoid holding heat on the bonds, tapes or wefts.